Intro
This is a nifty foam piece I am including for free with cases!
It is optional, however it adds a bit more padding for your device and helps keep the buttons from being pressed while in the case.
Installation is quick and easy!
Step 1
Open the case and set it on a stable surface facing right side up.
Take the Button Cutout Foam and carefully peel off the white adhesive backing paper.
Step 2
Line up the Button Cutout Foam on the
LEFT side of the case (The side that the latch is on).
Make sure the hole cutouts are on the bottom side.
Note the orientation in the photo.
